Gumstix Pi Conduit LoRa Gateway

In stock
PKG900000000572
$84.00

Gumstix Pi Conduit LoRa Gateway is an LTE-ready LoRa® gateway with a NimbeLink® Skywire™ connector, Ethernet over USB, and header for the RisingHF RHF0M301 gateway and concentrator module. This board is for engineers and makers looking to test the possibilitys of LoRa.

Save $1999 when customizing this Raspberry Pi Board with no manufacturing fees until the end of April!
Customize now with Geppetto

Gumstix Pi Conduit LoRa Gateway Ethernet

With the Raspberry Pi R Compute Module or CM3 and the RHF0M301 gateway module, the Gumstix Pi Conduit can deliver long-range communications over LoRaWANTM between the Internet and LoRa R devices.

Add a NimbeLink R SkywireTM LTE modem and deploy this gateway anywhere. The LoRa Gateway and Concentrator module used in this board can be used if you're developing for smart city, wisdom agriculture, metering (water meter, electric meter, or gas meter), or all kinds of other long range IoT applications.

Other connectors:
1 × Halo Electronics Low-Profile RJ-45 Connector What’s included
1 × RPi Compute LoRa Gateway Key component
1 × Micro B USB Plug
1 × SODIMM Connector
1 × Connector (Power Jack Medium)
1 × LAN9512 Ethernet Controller and USB Hub
1 × FTDI FT232RQ USB UART Interface

Raspberry Pi Support is Growing! Choose from a host of Gumstix Pi HAT or Raspberry Pi CM boards to power your Pi. or Design your own in Geppetto in minutes. No $1999.00 Manufacturing Fee - Starting Pi Day (March-14-2020 - April-30-2020)

Included Components
RPi Compute LoRa Gateway

RPi Compute LoRa Gateway

Ethernet

10/100 Ethernet via USB 2.0

USB Device

Micro B USB Plug

USB Host

2-port USB 2.0 hub

Key Components
Micro B USB Plug

Micro B USB Plug

SODIMM Connector

SODIMM connector to DDR2 200 pin module, such as the Raspberry Pi Compute Module

Connector (Power Jack Medium)

PJ-018H-SMT, medium size (1.65mm), fits EIAJ-2 plug

LAN9512 Ethernet Controller and USB Hub

IC USB 2.0 ETHER CTRLR 64QFN

FTDI FT232RQ USB UART Interface

Connect to an RS232 serial terminal over USB with the FTDI FT232RQ interface

Specs
Mating Connectors

Please read the instructions in the README file carefully before starting. Instructions and functions are explained in the file.

Files that are needed (such as bootloader and operating system) to create a bootable disk image, are available below.

Our Support page links additional resources.

Software Version:

COVID-19 has affected our supply chain. Please expect delays on your orders while we do everything we can to fulfil them.