Pre-GO

Backordered
PKG300060
$46.00

Standard precision GPS board

Pre-Go is a tiny, precision geolocation board powered by the u-blox NEO 7M GNSS receiver, featuring an integrated antenna.

Pre-GO

Featuring the u-blox Neo-7M GNSS module, the PreGO-SMA Board offers a low-cost positioning solution for your location-aware project, delivering ±2.5 meter accuracy. High quality global positioning in a 30x24mm form factor.

Connectors

Pre-GO modules can connect to any host board with an available UART connection. Logic levels are at 3.3V, and the board is powered by the 5V supply; however, by removing and replacing a jumper resistor, the board can be powered by a 3.3V source.

The GPS antenna is on the board; look at our other board with an SMA connector instead to allow external placement of an antenna.

Customization alternatives

A Geppetto designer has the choice of including a header on a custom-design that connects via 5-pin cable to one of these PreGO boards as shown by these examples.

Alternatively, the GPS module can be placed directly on a board.

Related Posts

Learn more about this product by checking out the following:

Articles from Gumstix blog

GPS
Width

30 mm W

Length

21 mm L

5-pin GPS Connector

Serial GPS

Key Components
DF13 R/A 5Pos 1.25mm SMT 5 position R/A connector for UART (DF13 series) Specs
UBlox Neo-7M GPS Receiver Module UBlox Neo-7M GPS Receiver Module Specs
Mating Connectors