Pre-GO with SMA Connector

In stock
PKG300071
$39.00

Standard precision GPS board

Pre-GO with SMA Connector is a tiny precision geolocation board powered by the u-blox NEO 7M GNSS receiver, featuring an SMA connector to attach an external antenna (not included).

Pre-GO with SMA Connector GPS

Pre-GO with SMA Connector

Featuring the u-blox Neo-7M GNSS module, the Pre-GO SMA Board offers a low-cost positioning solution for your location-aware project, delivering ±2.5 meter accuracy with an SMA connector for an external antenna (not included). High quality global positioning in a 30x24mm form factor.

Connectors

This model includes an SMA connector for an external antenna (not included).

Pre-GO modules can connect to any host board with an available UART connection. Logic levels are at 3.3V, and the board is powered by the 5V supply; however, by removing and replacing a jumper resistor, the board can be powered by a 3.3V source.

Custom alternatives

A Geppetto designer has the choice of including a header on a custom-design that connects via 5-pin cable to one of these Pre-GO boards as shown by these examples. Alternatively, the GPS module can be placed directly on a board.

Related Posts

Learn more about this product by checking out the following:

Articles from Gumstix blog

GPS

UBlox NEO 7M

5-pin GPS Connector

Serial GPS

Key Components
DF13 R/A 5Pos 1.25mm SMT

5 position R/A connector for UART (DF13 series)

Specs
SMA Jack

CONN SMA JACK STR 50 OHM PCB

UBlox Neo-7M GPS Receiver Module

UBlox Neo-7M GPS Receiver Module

Specs
Mating Connectors