AeroCore 250 for Overo

In stock
PKG300288
$139.00

AeroCore 250 for Overo is an expansion board custom designed specifically for 250-sized quadcopters (250mm x 250mm, motor to motor). It is part of the AeroCore 2 Product Suite.

AeroCore 250 for Overo

This board supports PX4 autopilot software version 1.8.2 or earlier. Future releases will not be supported. We do not recommend it for new designs.

AeroCore 2 series expansion, based on the Overo COM, custom designed specifically for 250 sized quadcopters (250mm x 250mm, motor to motor).

This board was designed in Geppetto and later customized by hand to fit the square shaped mounting platform of a quadcopter. As part of the customization, the Overo COM connector was placed diagonally on the board.

This board needs a WiFi-enabled Overo COM, such as the Overo AIRStorm-Y, antenna for WiFi, a GPS board, such as the PreGO PPP with SMA and antenna for GPS (all sold separately).

Included Components
Zyro 250 Overo

AeroCore based main board for the Zyro 250 frame with Overo COM.

Barometer

Included

Board-To-Board Connector

2 x 70-pin AVX connectors

Gyroscope

ST L3G4200D 3-Axis Gyroscope

Processor

ARM Cortex-M4 Microcontroller

Product Family

Overo

USB Console Port

FTDI USB-UART

5-pin GPS Connector
Key Components
Magnetic Buzzer SMT (5V 30mA 92dBA)

BUZZER MAGNETIC 5V 12.8MM SMD

Specs
FTDI FT232RQ USB UART Interface

Connect to an RS232 serial terminal over USB with the FTDI FT232RQ interface

Specs
ST L3G4200D 3-Axis Gyroscope

Low-power three-axis angular rate sensor able to provide unprecedented stability of zero rate level and sensitivity over temperature and time.

Specs
Memory (SPI FRAM 1MB 1.8V)

Memory (SPI FRAM 1MB 1.8V)

Specs
MS5611 Barometric Sensor

A high resolution altitude and digital atmospheric pressure sensor accurate to within 10 cm.

Specs
Mating Connectors
70-Pin AVX Connectors (Female – Overo Expansion)

Connect an Overo COM to an expansion board with these 70-pin AVX connectors.

Specs

Please read the instructions in the README file carefully before starting. Instructions and functions are explained in the file.

Files that are needed (such as bootloader and operating system) to create a bootable disk image, are available below.

Our Support page links additional resources.

Software Version: